Welcome to the LX Forum - Dodge Charger | Dodge Challenger | Dodge Magnum | Chrysler 300 Forum.
If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
Here we are transferring the paper template to the other side:
Using paint to mark the area to cut
Now is a great time to create the actual pattern that will be included in the kit, this will be much easier to use:
Now for the CARnage moment I've been waiting for for months he he he!! Make sure to hold the air hack saw blade at a slight (5 degree) angle as to make the inner cut larger than the outer cut.
Threaded Mode