DMH Low Profile Electric Cutouts - Write Up

[BOS/SRT]

I got the cutouts today, still waiting on new mounting plates from DMH and upgraded gasket from Modern Muscle. I should have the new mounting plate by Friday with they're gasket, which I will use untill MM gasket comes in, then I will swap.

Since the low pro cutouts are used I cleaned them thoroughly and tested them out and both are working great. Although I noticed that one cutout is slower than the other, not sure if it's an issu. Actually the movement is the same speed, just that one is slightly delayed.

I misunderstood from previous theads on what was needed to run the wiring properly. I had thought that they required a 30a fuse, but not so, they only require a 20a. I decided to wire the same as everyone else, tapping into the cig lighter, which is already 20a. I never used the lighter and I always charge my cell from the arm rest connect. So I tapped the positive into the positive line for the lighter and ground as well. Didn't seem like there was a reason for mento ground it anywhere else. I removed the lighter connect and is zipped with cutout wire, tucked in. I also couldn't decide where to place the switch, didn't want to drill any holes on panels or bezels and plan on eventually doing a BT switch plate. So for now, I removed the actual lighter assembly, which left a hole for me to place the switch for now. The hole is a little bigger, so tomorrow I will find away to secure it in place.

Of course I tested the cutouts multiple times during installing the wire and switch and all is working perfectly. I hope to have the cutouts installed on Monday or possibly Saturday, depending on when the mounting plate gets here. Once it's in I will post pix of setup and video for sound difference.

Thanks to all that put in they're input and special thanks to STROGUY (Randy) for his patience and guidance.