Thanks to XE Ryder for putting together a hell of a write-up, and also Ron380 for his thread, I was able to finally install the REM rear strut tower brace that's been gracing my living room floor for some time now ... lol



Started with trimming the floor piece ... turns out I should've trimmed about a half-inch more, but it fit OK anyway :

http://i229.photobucket.com/albums/e..._rearREM-1.jpg

http://i229.photobucket.com/albums/e..._rearREM-2.jpg

http://i229.photobucket.com/albums/e..._rearREM-3.jpg

http://i229.photobucket.com/albums/e..._rearREM-4.jpg

http://i229.photobucket.com/albums/e..._rearREM-5.jpg

http://i229.photobucket.com/albums/e..._rearREM-6.jpg

http://i229.photobucket.com/albums/e..._rearREM-7.jpg

http://i229.photobucket.com/albums/e..._rearREM-8.jpg

Done :
http://i229.photobucket.com/albums/e..._rearREM-9.jpg

And how camouflaged it became once I re-loaded all the crap I normally carry around ... lol :
http://i229.photobucket.com/albums/e...rearREM-10.jpg

:gr_grin:

Originally Posted by BOS/SRT (Post 2902) Gabe, nice job! You notice the difference?